What is the process of hydraulic cylinder installation and cleaning? The pipelines of hydraulic cylinders need to be cleaned after they are installed. During operation, they should not pass through the cylinder block. It is very important to install a bypass pipeline in front of the oil port of the cylinder block. Otherwise, foreign matters in the pipeline will enter the cylinder. Once they enter, it is difficult to remove them from the outside. Instead, they will be transported into the cylinder. In addition, the removal method of foreign matters in the installation pipeline operation shall be considered during cleaning.
When the pipes of hydraulic oil cylinders are cut during processing, there should be no left over during deburring at both ends of the pipes after the fixed length processing. The reason for the mixing of welding foreign matters is to place steel pipes near the welding pipeline operation site. All pipes placed near the welding operation site shall be sealed. It must also be noted that the pipe fitting materials should be fully prepared on the dust-free workbench.
As a simple sealing material, the hydraulic oil cylinder needs to use its polytetrafluoroethylene plastic sealing belt frequently in the process of installation and inspection. If the winding method of linear and belt sealing materials is wrong, the sealing belt will be cut off and enter the cylinder. The wire belt seal will not have any impact on the winding of the sliding part, but it will cause the one-way valve of the cylinder to act flexibly or the buffer regulating valve cannot be adjusted to the end; For the circuit, it may cause the action failure of reversing valve, overflow valve and pressure reducing valve.
To a certain extent, the scratched part of the hydraulic oil cylinder needs to be treated with its angle grinder. When the grinding depth is more than 1mm, the groove will be effectively polished along its guide rail during operation. When used, * is a dovetail groove. The drilling at both ends of the scratch is deepened and the stress condition is changed.
