How to debug the hydraulic station? The first thing to debug the hydraulic station is the pump. At that time, we used the ordinary plunger pump. Our designers bought the pump according to the order under the demand, so we generally do not adjust the pump. We do not know whether your pump can meet the pressure of your oil circuit.

Then, there is an overflow valve at the beginning of the general hydraulic oil circuit to prevent the valve and other components from being damaged by excessive pressure. I usually adjust this first. The value is lower than the * working pressure of your hydraulic element and higher than the required pressure.

*It is to adjust the pressure of each circuit. Pressure relief valve or something. The pressure can be adjusted slowly according to the demand. If you use a proportional valve, it is to adjust the speed of the oil cylinder. And can be adjusted according to the production efficiency.

In fact, there is no unified adjustment method for the hydraulic station, and it depends on whether there is any influence between the branches. If it is controlled by PLC, it should be adjusted in combination with the program, and the effect will be better.

The above is the relevant introduction in this respect. I hope it will be helpful to your work.